[Vincent98]

I want to activate it with Makelangelo 7.28.2 or 7.26.0. It depresses me when mistakes occur.

[Vincent98]

[Vincent98]

You can try to view it again. I have successfully installed the code I downloaded from the Github link, but the “conect” button is not active in the makelangelo application. I guess I need to add Makelangelo file to Marlin.

[Vincent98]

Dear Dan, first of all many thanks for your reply and help. I downloaded the code and it was successfully uploaded to the card. I’m out right now, when I get to my office, I’ll run it with the mechanism and try it. There is one more thing I am wondering about. I activated the X and Y sections on the motor driver card, but I think Y and Z are active in the code. Should I replace the motor driver? I think the photos I took below will help me explain. Sorry for my English, I’m Turkish.

1- https://drive.google.com/file/d/1NLEJUEMYNIeSLtOpleVAU0jJd5Lai-Wm/view?usp=sharing
2- https://drive.google.com/file/d/1WjJRg8l61ogv8dxWNVJu3shi8L9oOEa5/view?usp=sharing
3- https://drive.google.com/file/d/1j2NfVJ25aWj6rj-c_-L8749Ye07q7TmC/view?usp=sharing

[Vincent98]

https://drive.google.com/file/d/1cC0ABJa7rFIwuDQpDQwkzjpfC4qUMyra/view?usp=sharing

[Vincent98]

Thank you Dan!

[Vincent98]

Thanks for the answer. I ran the old version Makelangelo-7.11.0, but the stepper motors are spinning very slowly and draw the line. Where did I go wrong? I’ve been dealing with this for weeks. I would be grateful if you help.

[Vincent98]

Hi, the motherboard I use is Arduino Uno R3 and Motor Shield. Is there a suitable firmware for Makelangelo-7.28.2? (the code in your robot’s brain is not the version I expected) I’m getting an error.

[Author]

Posts