[richyrich140db2000]

Hello Dan,

The problems I’m having is:

only 1 motor is responding on X access no other access has power output and the motor is putting out a annoying high frequency humm. Yes the stepper driver power has been adjusted.

The Lcd display I’m using is the “reprap smart lcd controller with built is SD card reader”. It gets power but dose not display anything and the built in speaker puts out a high frequency dog whistle sound. It’s annoying as hell.

What pins should I use for the servo?

Thanks again for the help.

[richyrich140db2000]

Thank you for the reply’s

I’m glad to hear that it can and should work, so now I just need some help.

Question for you Bulp, could you share your config sketch file ?

I believe somewhere in the config file something is missing.

Thanks again for the reply’s and any help you can give,

[Author]

Posts