ZARPLOTTER Makelangelo 5 FIRMWARE

Shop › Forum › Makelangelo Polargraph Art Robot › ZARPLOTTER Makelangelo 5 FIRMWARE

  • This topic has 6 replies, 3 voices, and was last updated 6 years ago by Dan.
Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • 2018-06-28 at 13:49 #20223
    starsk
    Participant

    Hello. I am looking if somebody can help to understand why the extruder driver is giving me more rotation that the XYY drivers.

    Can I change this in the Firmware.

    Thanks

    2018-06-28 at 13:50 #20224
    starsk
    Participant

    Hello. I am looking if somebody can help to understand why the extruder driver is giving me more rotation that the XYY drivers (I am using Ramps).

    Can I change this in the Firmware.

    Thanks

    2018-06-28 at 13:56 #20225
    Dan
    Keymaster

    Check the microstepping switches on the driver.

    2018-11-27 at 12:51 #21233
    post
    Participant

    Hi

    I am building a Zarplotter and are using a ramps 1.4 board. motor xyz are working as they should but the motor I have connected to the E0just vibrate back and forth when i move the plotter head or starting a drawing. it seems like it get confused on witch direction it should go.
    any suggestions?

    2018-11-27 at 13:53 #21234
    Dan
    Keymaster

    D0 command should jog a motor. I forget the exact details atm. But it should give you a way to test that motor independently.

    2018-11-30 at 11:30 #21268
    post
    Participant

    Hi
    It was a bad cabel connector on one of the motors;)
    works fine now

    2018-11-30 at 14:02 #21270
    Dan
    Keymaster

    MFW no videoooooooo…… http://healthyfoodkings.com/wp-content/uploads/2015/07/Dehydration-900×506.jpg

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.