Wire Bender
- This topic has 1 reply, 2 voices, and was last updated 4 years, 4 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I have a “ open source “ sketch for wire bending. It require lengths of wire bends etc to be entered directly into sketch. Spent hours trying to locate site so g- code can be directly entered on to sketch from say fusion360 Rhino or similar. Link …https://howtomechatronics.com/projects/arduino-3d-wire-bending-machine/ Is the above code possible. It’s probably expensive to write . However if is possible could l have a contact. Or shock me with a price to write
Makelangelo firmware could work with this machine. Three stepper motors and a servo.
What control board are you using?
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
