Using Makelangelo 3.2 on Glass Window
- This topic has 2 replies, 2 voices, and was last updated 8 years, 1 month ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Hi All,
We are trying to use the Makelangelo on glass with the suction cups, however, I think it is skewing the picture in the top corners because the motors are on a bit of an angle. Any thoughts?I have already changed the settings for size of the machine and size of the paper. In addition I have tried a higher and lower ‘home’ location.
If your rectangles are appearing “smile” shaped then I would suspect your home location is different from the software’s assumption.
The next likely culprit is the software settings are wrong – perhaps the software setting for measurement from motor to motor does not match reality.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
