Use Makelangelo on a Polargraph
- This topic has 1 reply, 2 voices, and was last updated 8 years, 9 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I’ve built a V-Plotter with an Arduino UNO and the Adafruit Motorshield V1. It is running and drawing.
It seems that the Hardware is very similar to the Makelangelo, so I was wondering if I can use the Makelangelo firmware and controller on the same hardware setup? I’ve tried it. but the motors turn only in one direction.
Are there pins to be remapped in the firmware? Has anyone tried that before and give me a headstart?
Jan
An UNO and an AMSv1 are the same hardware I use with the Makelangelo. The makelangelo-firmware should work right out of the box.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
