Stewart Platform 2 power supply upgraded to 3a
- This topic is empty.
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Shop › Forum › Stewart/Gough Platforms › Stewart Platform 2 power supply upgraded to 3a
6 motors drawing 0.3 amps each should draw 1.8 amps, right? Right. Until… After about 15 minutes of run time the motors warm up and draw more than 2 amps. If you find that on long runs your control board is “browning out” – spontaneously resetting – then upgrade to a 3 amp power supply and it should be fixed.