START AT LINE #
- This topic has 2 replies, 2 voices, and was last updated 5 years, 6 months ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Dear Dan,
what is meant by “start at line #”? How can I use this function and
where can I find or define the “lines” Could you give an example for it?If I save the gcode of a drawing to a file and open that file in a text editor then I can surf to any line number.
Now say I’m drawing a picture and in the middle USB gets disconnected or something.
I can use “start at line #” to begin the drawing at that line in the file.to be clear, I don’t HAVE to save to a file first.
There is a temp file created when the image is generated, and it’s the exact same as one you would save to somewhere more permanent.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
