Sir Rampsalot
- This topic has 1 reply, 2 voices, and was last updated 7 years, 1 month ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hi,
I just wanted to post a heads up for the Sir Rampsalot driver that I used to get it working with M542T microstep drivers on a large scale 3D delta printer I’m working on.
The connections are as follows:Driver Side / Sir Rampsalot Side
PUL+ S
PUL- G
DIR+ D
DIR- G
ENA+ E
ENA- GNice. I have the same results here.
No luck with a DM320T. 🙁
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
