manual driving don't stop
- This topic has 4 replies, 2 voices, and was last updated 7 years, 10 months ago by .
Viewing 5 posts - 1 through 5 (of 5 total)
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
Shop › Forum › Makelangelo Polargraph Art Robot › manual driving don't stop
Tagged: endelss move
hi
I just bought the newes firmware 7.0.0 and software 7.8.0.
when I use left/right in/out in “settings” the motors move correctly.
but when I move with “manual driving” both motors turn endless in the
correct direction.
arduino IDE 1.6.12
?
What Makelangelo hardware version are you using? 2? 3?
I will try a test here on our machines to repeat what you are seeing.
hi dan
I’m using makelangelo v2
hi dan
I downloaded an older version of the firmware, and now it works with software 7.9.0
but I’m not sure which version I downloaded 🙁 I cant find a version number in the firmware coode.
where can I find the version number?
thank you!
Look for EEPROM_VERSION