manual driving confusion
- This topic has 1 reply, 2 voices, and was last updated 8 years, 2 months ago by .
-
Posts
-
Makelangelo 2.5.2 with current firmware 1.40 and software 7.7.1
settings set (607, 900), set home
Question: Manual driving – “Top”, “Bottom” OK, “Right” – motors drive down endlessly, never stop, finally I have to disconnect power and USB, ultimately start over. What is going on ??
re-loaded firmware 1.40 (question: firmware version for download is 1.40, send M100 and “Firmware V6” is reported – ??)
forward troubleshooting ideas & thanks
There was a bug in Right that was going way too far. It will be fixed in the next release on Monday.
You’re right about the version inconsistency. The v1.4 is the source code version. V6 is the EEPROM version. The difference is really esoteric. I will find a way to make them match so it makes more sense. Probably the next official version of the firmware will jump from 1.4 to 7.0.0 and the EEPROM version will also be 7 so they match.
- You must be logged in to reply to this topic.
