Makelangelo 2.5
- This topic has 1 reply, 2 voices, and was last updated 7 years, 10 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hello,
I plan on wall mounting my Makelangelo 2.5 when I receive it, and I had a few questions that I’m hoping to get answered.
If I only plan on printing 11×17 drawings, can I reduce the size of the board recommendation of 3×4? I understand I need clearance for the counter weights, but the board will be mounted at eye level, so there will be plenty of room to allow unencumbered travel.
Can I find the documentation for setting up the robot online some place?
Thanks in advance!
Yes. Run the software, open settings, and set your machine type to 2.5. You will then have options to change the machine size (3×4) and the paper size. 11×17 sounds like US legal, maybe? Should be fine.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
