Inifinite first motion

Shop › Forum › Makelangelo Polargraph Art Robot › Inifinite first motion

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • 2016-10-12 at 10:32 #11254
    Anonymous
    Inactive

    Hi there.

    I’m having an issue that I don’t know how to solve.

    My servo and motor looks to work as they should, but each time that i run a move (manualy control or start a G-code) the first motion never stops.

    Pen up, pen down works.
    The In&Out controls in settings works.

    I’m using an arduino UNO with firmware_ams 1.6.1, set step per turn at 200, and i didn’t define the limit switch
    My shield is a Dk Electronics.

    Any idea what’s wrong in my setup?
    Thanks

    2016-10-12 at 12:19 #11255
    Dan
    Keymaster

    What is the gcode command you are sending? can you post the log.html?

    2016-10-12 at 12:20 #11256
    Dan
    Keymaster

    eh, please post it to https://nopaste.me/ with “never time out” so the link will stay good.

    2016-10-12 at 14:55 #11259
    Anonymous
    Inactive

    I didn’t build the drawbot yet, i’m just trying to make the electronics works.
    I’m having a good answer of the motor and the servo, but as soon as i try to make it move of 1mm throught the manual command, motors run and never stop (same thing if I run a file). I tried then to send a M18 but nothing change.
    The only way to make them stop is to disconnect and reset arduino.

    It looks like it isn’t counting steps…

    2016-10-12 at 14:57 #11260
    Dan
    Keymaster

    I can only offer good support on robots we built. Even the smallest change in your design could make a world of difference.

    2016-10-12 at 14:57 #11261
    Anonymous
    Inactive

    https://nopaste.me/view/b9ee5f2c

    2016-10-12 at 14:58 #11262
    Dan
    Keymaster

    Yeah, I don’t see anything wrong here. 🙁

    2016-10-12 at 15:05 #11263
    Anonymous
    Inactive

    >I can only offer good support on robots we built. Even the smallest change in your design could make a world of difference.

    Something wrong in my setup?

    2016-10-18 at 09:58 #11299
    Dan
    Keymaster

    Yes. Something I can’t see from here.

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.