home position problem
Shop › Forum › Makelangelo Polargraph Art Robot › home position problem
- This topic has 8 replies, 3 voices, and was last updated 6 years, 8 months ago by Vladimir.
-
AuthorPosts
-
2018-01-01 at 06:10 #15154raphmannParticipant
Hi Dan,
when I will draw with SD-Card, I have the problem, that he don´t
save the home position I gave him. You will see it in this clip:Raphael
2018-01-01 at 13:44 #15163DanKeymasterHuh. I’d have to ask the robot “please keep telling me where you are while you are running” so I could get a better idea what it is thinking.
2018-01-02 at 04:49 #15165raphmannParticipantHi Dan,
ok. What could I do? With SD-Card Makelangelo 3.2 wobbles at the beginning and
the drawing is not at the right place when it begins after wobbling. Also the
drawings are condensed. It sould be wider.With USB-Connection the drawing stops. – And it is also condensed.
Mr. Makelangelo does not like to work for me. What shall we do?
2018-01-03 at 12:13 #15181DanKeymasterWhen you run it over USB, does it behave correctly?
2018-01-03 at 13:08 #15183DanKeymasterI’m running some tests now.
2018-01-03 at 15:09 #15187raphmannParticipantWith USB home position is correctly, but not the drawing:
– it interrupts
– and it is condensed2018-01-05 at 00:46 #15194VladimirParticipanthttps://youtu.be/PHdk4v_SBtw
I have similar problems with the settings
Through the cable the machine stops, the SD card does not start the home position.
The video is great but you have to look ….
To be honest, I’m at a dead end, every attempt to draw something ends in a breakdown.2018-01-05 at 15:30 #15203DanKeymastera problem has been found in the firmware. when I click “this is home” the position is reset to 0,0 instead of the correct home position. A patch has been submitted.
Please
– go to https://github.com/MarginallyClever/Makelangelo-firmware/tree/dev
– “clone or download”
– install the latest firmware
– report results here2018-01-09 at 09:25 #15231VladimirParticipantComands: “This is home” and “Go home” work as expected. Thank you !!!)
P.S.
in the firmware is not enough command
“Start at line #” -
AuthorPosts
- You must be logged in to reply to this topic.