Feedrate not working
- This topic has 1 reply, 2 voices, and was last updated 7 years, 9 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hello,
I try out the GcodeCNCDemo4AxisRAMPS sample,
it is working, except the feedrate…
If I try out “G01 Z100 F1000;” or “G01 Z100 F10;” the motor speed is the same.
What is wrong??Greetings, Michael
Did you dig into the code at all? If you try “G0 F100” and then “M114” does it report that the feed rate changed to 100?
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
