commit 86 fixes arcs
- This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
arcs (g2, g3) were breaking if any of the four parameters (XYIJ) were left out. I’ve fixed them in the bleeding edge version of the firmware. Bonus: they process faster and sound smoother on both 2.5 and 3.0 machines.
I’ve noticed config values in the Makelangelo software seem to round off. I try to save paper size 609.6 and it reloads as 610. Is anyone else seeing this? I haven’t found the cause yet.
I’m excited to try the new changes. One minor change I did noticed over the weekend is that the word “menu” now appears before all of the menu commands (which I don’t think was there before). Regards.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
