Jigsaw Robot 2: mounting brackets

This shot was taken in Repetier-host, right after I “sliced” the 3d model into instructions for the 3d printer. This is a WYSIWYG view of the final product.

These four brackets will hold one of the linear actuators from the jigsaw robot onto the board I showed in an earlier post. I put a bracing side on it to it won’t flex in the wrong direction and a flange in the corner coz I hear that absorbs a lot of stress.

The car is also being reprinted because it was flimsy and didn’t hold well. Note the two holes in the center! they will be used to attach the Y axis to the X cars.

That’s all for now. Follow on instagram if you want to see up-to-the-minute pictures when the parts come off the printer.